Dear All,
I have upgraded my Cimplicity SCADA software the upgradation was successful and I followed one manual that was sent from you in which the upgradation steps were defined. The previous system consisted applicom card and OPC server because the PLC is of Siemens and SCADA is of GE now in the newer version i.e.8.2 GE is not supporting applicom any more so we also had to change the OPC server as well.
My issue is with the addresses that contain offset and data type BOOL. Because of this address offset I am not able to find the exact bit that represents the particular address that is mapped in SCADA. Now when I change the address and give the address of my OPC scout here the Address offset columns becomes inaccessible why is it like this can you help me out in this scenario…
Thank You & Best Regards
I have upgraded my Cimplicity SCADA software the upgradation was successful and I followed one manual that was sent from you in which the upgradation steps were defined. The previous system consisted applicom card and OPC server because the PLC is of Siemens and SCADA is of GE now in the newer version i.e.8.2 GE is not supporting applicom any more so we also had to change the OPC server as well.
My issue is with the addresses that contain offset and data type BOOL. Because of this address offset I am not able to find the exact bit that represents the particular address that is mapped in SCADA. Now when I change the address and give the address of my OPC scout here the Address offset columns becomes inaccessible why is it like this can you help me out in this scenario…
Thank You & Best Regards
