Hello to everyone.
i have Safetynet Pac8000 8851-LC-MT with Controller Carrier 8751-CA-NS which is powered by the Redundant 8913-PS-AC power Supplies. The controller are redundant but at the moment i am using only one A as the other is order process. There's is auto configured tag(see link-2) for the Power Supply Failures. i am using the pair 7 and 8(see link-1) to connect with the AUX pin no 10 on both Power Supplies.The Tag of only controller A is generated as the B is not yet installed. After download when i shut off one power supply the tag value do not change to 0 instead its always 1. Is this a wiring issue of software or am i skipping any step.
Link-1:Power Supply and Controller Carrier Datasheet page 19.
http://www.astor.com.pl/downloads/ka...%20net/9.2.pdf
Link-2 :AutoConfigureTag on Page 12 of this document.
ftp://ftp.technolink.spb.ru/DOCS/GE_...Oct%202006.pdf
Looking forward for you help and suggestions.
Regards;
sahmad
i have Safetynet Pac8000 8851-LC-MT with Controller Carrier 8751-CA-NS which is powered by the Redundant 8913-PS-AC power Supplies. The controller are redundant but at the moment i am using only one A as the other is order process. There's is auto configured tag(see link-2) for the Power Supply Failures. i am using the pair 7 and 8(see link-1) to connect with the AUX pin no 10 on both Power Supplies.The Tag of only controller A is generated as the B is not yet installed. After download when i shut off one power supply the tag value do not change to 0 instead its always 1. Is this a wiring issue of software or am i skipping any step.
Link-1:Power Supply and Controller Carrier Datasheet page 19.
http://www.astor.com.pl/downloads/ka...%20net/9.2.pdf
Link-2 :AutoConfigureTag on Page 12 of this document.
ftp://ftp.technolink.spb.ru/DOCS/GE_...Oct%202006.pdf
Looking forward for you help and suggestions.
Regards;
sahmad