Does anyone have any experience migrating from the DPC 33XX series of RTU to the Control Wave as the data concentrator for Ifix?
We are using ifix 5.0 / BR3 6.31 / OPENBSI 5.7 SP2_Pacth C / Ethernet from PLC to PC
2 radio frequencies operating at 9600 baud, F#1 with 22 and F2 26 nodes these nodes consist of half control wave micro and the other half a combination of 3330 and a few 3305.
The issue is that when I transfer everything over to the new Control Wave RTU my data quality drops considerably. Instead of updates every 20-60s I start getting data into my database at much longer intervals sometimes 5min+
Anyways, if there are any BR3 experts out there or anyone with any thoughts I'm trying to figure out where the problem is i.e. BR3 or RTU or software etc...
I would appreciate the assistance. I do have my Emerson/Bristol rep working on this as well but so far we haven't figured it out...
We are using ifix 5.0 / BR3 6.31 / OPENBSI 5.7 SP2_Pacth C / Ethernet from PLC to PC
2 radio frequencies operating at 9600 baud, F#1 with 22 and F2 26 nodes these nodes consist of half control wave micro and the other half a combination of 3330 and a few 3305.
The issue is that when I transfer everything over to the new Control Wave RTU my data quality drops considerably. Instead of updates every 20-60s I start getting data into my database at much longer intervals sometimes 5min+
Anyways, if there are any BR3 experts out there or anyone with any thoughts I'm trying to figure out where the problem is i.e. BR3 or RTU or software etc...
I would appreciate the assistance. I do have my Emerson/Bristol rep working on this as well but so far we haven't figured it out...