I'm working with a client who uses the GE EPM 5100 meter (http://www.gedigitalenergy.com/multi...og/epm5100.htm), which communicates as a Modbus RTU slave. The Modbus address of the meter (which can be from 33 to 247) is set by three small pot switches mounted inside the meter case.
(Page 60 of the manual, Section 4.5.1, at http://www.gedigitalenergy.com/produ...ek-113391a.pdf)
I'm going to have to direct someone over the phone to find them and turn them to properly set the address, but the product manual doesn't make it clear exactly where those switches are mounted, and I heard that at first look, the on-site contact wasn't able to find them.
Has anyone worked with a GE EPM 5100 meter, and if so, do you recall where exactly those switches were (so I can properly direct my contact over the phone)?
Thanks!
(Page 60 of the manual, Section 4.5.1, at http://www.gedigitalenergy.com/produ...ek-113391a.pdf)
I'm going to have to direct someone over the phone to find them and turn them to properly set the address, but the product manual doesn't make it clear exactly where those switches are mounted, and I heard that at first look, the on-site contact wasn't able to find them.
Has anyone worked with a GE EPM 5100 meter, and if so, do you recall where exactly those switches were (so I can properly direct my contact over the phone)?
Thanks!