I connected a modbus device to a SCADA PC via ethernet switch.
Communication driver used is IGS Modbus TCP/IP.
If I connect other PC using Modscan through the same ethernet switch, I was'nt able to communicate.
If I close iFIX then I was communicate through MODSCAN in other PC.
Is there any settings in the IGS driver to avoid communication issue?
Communication driver used is IGS Modbus TCP/IP.
If I connect other PC using Modscan through the same ethernet switch, I was'nt able to communicate.
If I close iFIX then I was communicate through MODSCAN in other PC.
Is there any settings in the IGS driver to avoid communication issue?